Console Controller WTC-303
The most highly integrated console controller in the industry. It provides direct wiring for WTC’s proven magnetic keying system, Smart Controls or Standard Data Chain, MIDI input/output, PAL audio input/output, USB flash memory, user interface display and expression/crescendo analog inputs. Everything is contained in one small 7.25” x 7.25” board
Headphone Interface WTC-290
Headphone interface for use with the WTC-303 Console Controller. Includes a headphone jack with insertion detection and a volume knob.
User Interface Screen
A small black and white screen which displays information and interfaces with the WTC Console Controller. This screen is required to use the Console Controller.
61 Input Encoder 122 Output Decoder WTC-215
An input/output board for stop-action controls. It provides an input for the switch and two outputs for the ON and OFF coil of each control. The inputs can be used independently from the outputs, and the outputs can be used for purposes other than driving coils. The inputs are negative common and the outputs drive low. The outputs are fully protected from shorts and over-current situations, with diagnostic LED’s to indicate the current state of the board. The input and output functionality is configured by the control system.
61 Input Encoder 122 Output Decoder WTC-265
An input/output board for stop-action controls. It provides an input for the switch and two outputs for the ON and OFF coil of each control. The inputs can be used independently from the outputs, and the outputs can be used for purposes other than driving coils. The inputs are positive or negative common and the outputs drive low or high, both are selected by a jumper. The outputs are fully protected from shorts and over-current situations, with diagnostic LED’s to indicate the current state of the board. The input and output functionality is configured by the control system.
122 Input Encoder WTC-223
An input board for keying, piston, or toe stud inputs. The inputs can be either positive or negative common, set with a jumper. The input functionality is configured by the control system.
Smart Expression/Crescendo Bargraph WTC-319
A 10-LED bargraph board to be used either horizontally or vertically in a group. Available with either all yellow LED’s or with eight green and two red LED’s, for use as a Crescendo/Tutti indicator.
Smart 7-Segment Display WTC-320
A 7-segment red LED numerical display. It can be configured to have 1-4 digits, stands ¾” high and is up to 2 inches long when configured for 4 digits.
Smart 73 Input Encoder WTC-323
An input board for keying, piston, or toe stud inputs. The inputs can be either positive or negative common, selected by a jumper. The input functionality is configured by the control system.
Smart 4 Input/Output Dimmer WTC-393
A small 4 I/O board, capable of PWM (pulse width modulated) outputs. When used with the WTC-303 Console controller this board can control up to 4 LED lights. The inputs and outputs are completely software configurable.
Smart SAM Driver
A small driver board to plug directly onto the back of a Syndyne SAM. This board moves the action intelligently and reports back to the controller the current state of the control.
Smart Drawknob Driver
A small driver board to plug directly onto the back of a Syndyne mechanism. This board moves the action intelligently and reports back to the controller the current state of the control.
Data Chain Converter WTC-280
This converter will convert legacy WTC data chains (Data, Clk, Stb) into the smart chain. This allows for systems that are using the legacy chain to add new smart controls. This same converter will convert in the opposite direction, allowing systems that use the Smart Chain to use legacy devices.